benikigai/plus-onePublic
Plus One
SHA-256 1788ee4ae4c65161700d3aa399bab31bff243865caf0a3db740d756f41d657cc
| operation | name | type | station | cycle_time_s_target |
|---|---|---|---|---|
| op:diffuser-place | Seat the light-ring diffuser in the top shell | place | sta:s1 | 5 |
| op:diffuser-stake | Heat-stake the diffuser | heat-stake | sta:s1 | 9 |
| op:button-place | Fit the plus button | place | sta:s1 | 4 |
| op:gasket-place | Place the two mic gaskets over the ports | place | sta:s1 | 6 |
| op:board-place | Place the main board in the top shell | place | sta:s2 | 10 |
| op:board-screw | Drive three board screws | screw | sta:s3 | 15 |
| op:adhesive-dispense | Dispense adhesive for the speaker and haptic | adhesive | sta:s4 | 8 |
| op:speaker-place | Place the speaker | place | sta:s4 | 5 |
| op:haptic-place | Place the haptic motor | place | sta:s4 | 5 |
| op:battery-mate | Mate the battery connector | connector-mate | sta:s5 | 8 |
| op:battery-place | Place the battery on foam tape | place | sta:s5 | 6 |
| op:ring-bond | Bond the magnet ring into the base | adhesive | sta:s6 | 8 |
| op:coil-place | Place the charging coil and ferrite inside the ring | place | sta:s6 | 6 |
| op:pad-press | Press the five pogo pads into the base | place | sta:s6 | 6 |
| op:base-close | Close the base onto the core | snap-fit | sta:s6 | 8 |
| op:polarity-check | Check ring polarity, pad height and the key | inspect | sta:s6 | 4 |
| op:flash-provision | Flash firmware and provision the unit ID | flash | sta:s7 | 24 |
| op:mic-cal | Calibrate the two mics | test | sta:s7 | 10 |
| op:imu-cal | Calibrate the motion sensor | test | sta:s7 | 6 |
| op:functional-test | Functional test: button, touch, ring, haptic, IMU, wired and wireless charge, audio loopback, RF check | test | sta:s8 | 40 |
| op:laser-mark | Laser-mark the unit QR on the base rim | label | sta:s8 | 6 |
| op:pack | Pack with the cable and card; no back ships | pack | sta:s8 | 10 |
22 rows.